The preheat Relay controls the preheater from an electric signal from the Engine Control Module (ECM). This function is used to warm up the inlet air during cold conditions. This provides more reliable starting and reduces exhaust emissions during cold starts. Vehicles can be equipped with or without the preheater.
Conditions for diagnostic trouble code (DTC):
1) Output activated
2) Short circuit to battery voltage on A14.EB:25
Observable symptoms
1) Intake air heater (IAH) relay never activated
2) Difficult to start in extreme cold
3) White smoke at cold start
Probable cause
1) Engine wiring harness
2) Connector
3) Intake air heater (IAH) relay
-
JOHN DEERE SERVICE ADVISOR 5.3.225 DATABASE AG + CF ENGLISH 2023
John Deere $250.00Rated 0 out of 5 -
PF Diagnose 2.0.2.23 Diagnostics Software 2013 – Full Heavy & Medium Duty with OBDII Support – Online Installation Service
PF Diagnose $60.00Rated 0 out of 5 -
CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )
CAT $65.00Rated 0 out of 5 -
Navistar international OnCommand service information 2018 software trucks
Navistar $50.00Rated 0 out of 5
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P0980 Shift Solenoid 3 (SS3) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2789 Clutch Adaptive Learning at Limit
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2641 Torque Management Feedback Signal – LRTP
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P097C Shift Solenoid 3 (SS3) Control Circuit – Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0977 Shift Solenoid 2 (SS2) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2684 Actuator Supply Circuit Voltage 3 Open (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0974 Shift Solenoid 1 (SS1) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2724 Pressure Control Solenoid 1 (PCS1) – Stuck On
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2730 Pressure Control Solenoid 1 (PCS1) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5Rated 0 out of 5
-
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 679 FMI 7 (MCM) Pressure Limiting Valve (PLV) Staying Open
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 652 FMI 4 (MCM) Injector Cylinder #2 Needle Control Valve Abnormal Operation (MIN)
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 597 FMI 19 (CPC) J1939 Service Brake Switch Signal from Source #1, #2 or #3 Erratic
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Volvo All Engines (2010 Emissions) Fault Code: SPN 2659 FMI 10 PID: PPID 35 Engine Exhaust Gas Recirculation (EGR) Mass Flow Rate
All Engines (2010 Emissions)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P047F00 PID: EMS Exhaust Pressure Control Valve “A” Stuck Open
All Engines (2017 Emissions)Rated 0 out of 5 -
PACCAR MX (2004 Emissions) Fault Code: U1110 CAN – Message (RC_DR) Time-Out from Retarder System
MX (2004 Emissions)Rated 0 out of 5 -
Cummins ISB CM550 (1990-94) Fault Code: 387 PID: 91 SPN: FMI: 3 Accelerator Position Sensor Circuit
CumminzRated 0 out of 5 -
Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 16 PID: Engine Intake Manifold
All Engines (2010 Emissions)Rated 0 out of 5 -
Volvo All Engines (2013 Emissions) Fault Code: P06E800 PID: EMS Sensor Power Supply “C” Circuit High
All Engines (2013 Emissions)Rated 0 out of 5 -
Volvo Engine D11L (Tier 4) Fault Code: SID 70 FMI 4 Air Inlet Heater Driver #1
D11L (Tier 4)Rated 0 out of 5