“John Deere Service Advisor 5.4.44 2025 (AG & CF) | Nexiq USB Link 3 Compatible” has been added to your cart. View cart
The preheat function is used to warm up the inlet air during cold conditions both before and after cranking to make the starting easier and better for the environment at very low temperatures. This diagnostic trouble code (DTC) detects a faulty preheat function.
Conditions for diagnostic trouble code (DTC):
1) Preheating requested
2) The voltage at pin A14.EB:7 is less than 29?% of the battery voltage
Observable symptoms
1) Intake air heater (IAH) does not function
2) White smoke at cold start
3) Difficult to start in extreme cold
Probable cause
1) Wiring harness
2) Connector
3) Intake air heater (IAH) relay
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5
-
Volvo All Engines (2017 Emissions) Fault Code: P108013 PID: ACM Actuator Supply Voltage “D”
All Engines (2017 Emissions) -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 2791 FMI 3 (MCM) Circuit Failed High
DD13 EPA10 (2010-13) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 1675 FMI 0 PID: SID 39 Engine Starter Mode
All Engines (2010 Emissions)