“John Deere Service Advisor 5.4.44 2025 (AG & CF) | Nexiq USB Link 3 Compatible” has been added to your cart. View cart
The preheat function is used to warm up the inlet air during cold conditions both before and after cranking to make the starting easier and better for the environment at very low temperatures. This diagnostic trouble code (DTC) detects a faulty preheat function.
Conditions for diagnostic trouble code (DTC):
1) Preheating requested
2) The voltage at pin A14.EB:7 is less than 29?% of the battery voltage
Observable symptoms
1) Intake air heater (IAH) does not function
2) White smoke at cold start
3) Difficult to start in extreme cold
Probable cause
1) Wiring harness
2) Connector
3) Intake air heater (IAH) relay
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5
-
Volvo All Engines (2017 Emissions) Fault Code: P113B64 PID: EMS Turbo Compound Buffer Air Pressure Sensor
All Engines (2017 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 629 FMI 12 PID: SID 254 Electronic Control Unit (ECU) 1
All Engines (2010 Emissions) -
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 21 PID: 41 SPN: FMI: 4 8 Volt Supply voltage low
3406E (Prefix 5DS or 1LW) -
Volvo All Engines (2013 Emissions) Fault Code: P269100 PID: EMS Cylinder 6 Injector Data Incompatible
All Engines (2013 Emissions) -
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 97 FMI 15 (MCM) Water-In-Fuel Warning
DD16 EPA10 (2010-13)