“CAT ET 2026 Diagnostic Software” has been added to your cart. View cart
The preheat function is used to warm up the inlet air during cold conditions both before and after cranking to make the starting easier and better for the environment at very low temperatures. This diagnostic trouble code (DTC) detects a faulty preheat function.
Conditions for diagnostic trouble code (DTC):
1) Preheating requested
2) The voltage at pin A14.EB:7 is less than 29?% of the battery voltage
Observable symptoms
1) Intake air heater (IAH) does not function
2) White smoke at cold start
3) Difficult to start in extreme cold
Probable cause
1) Wiring harness
2) Connector
3) Intake air heater (IAH) relay
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5
-
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 97 FMI 15 (MCM) Water-In-Fuel Warning
DD13 GHG14 (2014-16) -
Volvo All Engines (2013 Emissions) Fault Code: P117E00 PID: EMS Driver Requested Launch Gear Too High
All Engines (2013 Emissions)