Volvo All Engines (2010 Emissions) Fault Code: SPN 91 FMI 3 PID: Accelerator Pedal Position 1
The pedal message is used to calculate fuel injection.
The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management.
The (VECU) Vehicle Electronic Control Unit is linked to the Engine Control Module (ECM) via these data lines.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A17.PB:8 is more than 4.7?V
Observable symptoms
1) The engine does not respond when accelerator pedal is pressed.
2) Missing kick-down effect
Probable cause
1) Connector
2) Accelerator pedal, Sensor
3) Signal wire, Short circuit to higher voltage
4) Open circuit, Ground wire
Related products
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P052064 PID: EMS Engine Oil Pressure Sensor/Switch “A”
All Engines (2013 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P011011 PID: EMS Intake Air Temperature Sensor 1 Bank 1
All Engines (2013 Emissions) -
-
-
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 2631 FMI 1 (MCM, ACM) Low Air Flow
DD16 EPA10 (2010-13) -
-
Volvo All Engines (2013 Emissions) Fault Code: P25A913 PID: EMS Piston Cooling Oil Control
All Engines (2013 Emissions) -
-
Volvo All Engines (2013 Emissions) Fault Code: P040600 PID: EMS EGR Differential Pressure Sensor Circuit High
All Engines (2013 Emissions) -
-
-
