Volvo All Engines (2010 Emissions) Fault Code: SPN 91 FMI 3 PID: Accelerator Pedal Position 1
The pedal message is used to calculate fuel injection.
The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management.
The (VECU) Vehicle Electronic Control Unit is linked to the Engine Control Module (ECM) via these data lines.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A17.PB:8 is more than 4.7?V
Observable symptoms
1) The engine does not respond when accelerator pedal is pressed.
2) Missing kick-down effect
Probable cause
1) Connector
2) Accelerator pedal, Sensor
3) Signal wire, Short circuit to higher voltage
4) Open circuit, Ground wire
![MAN MANTIS v666 EPC [09.2021] Spare Parts Catalog](https://www.ecuforcetruck.com/wp-content/uploads/2022/01/MANTIS-V666-300x300.png)
![Magic Tuner [paccar, Maxxforce, Detroit, Caterpillar, Delete]](https://www.ecuforcetruck.com/wp-content/uploads/2021/10/1-300x300.png)
Related products
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5 -
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 175 FMI 5 PID: Engine Oil Temperature
All Engines (2010 Emissions) -
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 111 FMI 5 PID: Engine Coolant Level
All Engines (2010 Emissions) -
-
Allison 3000 & 4000 Gen 4 Fault Code: P2761 TCC PCS Control Circuit Open
3000 & 4000 Gen 4 -
-
-
-
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P268E00 PID: EMS Cylinder 3 Injector Data Incompatible
All Engines (2013 Emissions)
