Volvo All Engines (2010 Emissions) Fault Code: SPN 91 FMI 3 PID: Accelerator Pedal Position 1
The pedal message is used to calculate fuel injection.
The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management.
The (VECU) Vehicle Electronic Control Unit is linked to the Engine Control Module (ECM) via these data lines.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A17.PB:8 is more than 4.7?V
Observable symptoms
1) The engine does not respond when accelerator pedal is pressed.
2) Missing kick-down effect
Probable cause
1) Connector
2) Accelerator pedal, Sensor
3) Signal wire, Short circuit to higher voltage
4) Open circuit, Ground wire
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P229E64 PID: EMS NOx Sensor Bank 1 Sensor 2
All Engines (2013 Emissions) -
-
Volvo Engine D12D AE E3 (Tier 3) Fault Code: SID231 FMI 2 SAE J1939 Data Link
D12D AE E3 (Tier 3) -
-
Volvo All Engines (2013 Emissions) Fault Code: P06B316 PID: EMS Sensor Power Supply “B”
All Engines (2013 Emissions) -
-
-
-
-
-
-
-
-
-
