The pedal message is used to calculate fuel injection.
The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management.
The (VECU) Vehicle Electronic Control Unit is linked to the Engine Control Module (ECM) via these data lines.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A17.PB:8 is more than 4.7?V
Observable symptoms
1) The engine does not respond when accelerator pedal is pressed.
2) Missing kick-down effect
Probable cause
1) Connector
2) Accelerator pedal, Sensor
3) Signal wire, Short circuit to higher voltage
4) Open circuit, Ground wire
-
download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software
Hitachi $76.00Rated 0 out of 5 -
Volvo Intermediate Storage File Encryptor/Decryptor (Editor) VISFED 0.3.2
Trucks software $35.00Rated 0 out of 5
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2641 Torque Management Feedback Signal – LRTP
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0980 Shift Solenoid 3 (SS3) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0979 Shift Solenoid 3 (SS3) Control Circuit – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0977 Shift Solenoid 2 (SS2) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2669 Actuator Supply Voltage 2 Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2684 Actuator Supply Circuit Voltage 3 Open (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P097B Shift Solenoid 2 (SS2) Control Circuit – Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P1790 Gear Shift Module 1 Calibration Invalid
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5Rated 0 out of 5
-
Volvo All Engines (2017 Emissions) Fault Code: P052013 PID: EMS Engine Oil Pressure Sensor/Switch “A”
All Engines (2017 Emissions)Rated 0 out of 5 -
Volvo All Engines (2013 Emissions) Fault Code: P117D00 PID: EMS Driver Requested Gear Too Low
All Engines (2013 Emissions)Rated 0 out of 5 -
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 51 PID: 168 SPN: FMI: 2 ECM Battery Power Intermittent
3406E (Prefix 5DS or 1LW)Rated 0 out of 5 -
Volvo All Engines (2013 Emissions) Fault Code: P20B173 PID: ACM Reductant Heater Coolant Control Valve Control
All Engines (2013 Emissions)Rated 0 out of 5 -
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 973 FMI 19 (CPC) Engine Retarder Selection Signal is Erratic
DD16 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 97 FMI 31 (MCM) Water-In-Fuel Warning – Ignored
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 5016 FMI 3 (ACM) Coolant Valve Supply Voltage Failed High
DD15 EPA10 (2010-13)Rated 0 out of 5