Volvo All Engines (2010 Emissions) Fault Code: SPN 91 FMI 4 PID: Accelerator Pedal Position 1
The pedal message is used to calculate fuel injection.
The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management.
The (VECU) Vehicle Electronic Control Unit is linked to the Engine Control Module (ECM) via these data lines.
Conditions for diagnostic trouble code (DTC):
1) Open circuit
2) The voltage at pin A17.PB:8 is less than 0.7?V
Observable symptoms
1) The engine does not respond when accelerator pedal is pressed.
2) Missing kick-down effect
Probable cause
1) Connector
2) Supply wire, Open circuit
3) Signal wire, Open circuit
4) Signal wire, Short circuit to ground
5) Accelerator pedal, Sensor
Related products
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: U300001 PID: EMS Electronic Control Unit
All Engines (2017 Emissions) -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0742 Torque Converter Clutch System Stuck On
1000 & 2000 Gen 4 $50.00 -
-
Volvo All Engines (2013 Emissions) Fault Code: P020313 PID: EMS Cylinder 3 Injector “A”
All Engines (2013 Emissions) -
-
Volvo All Engines (2017 Emissions) Fault Code: P049D99 PID: EMS EGR “A” Control Position Exceeded Learning Limit
All Engines (2017 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: U030100 PID: EMS Program Memory Test Cell Mode
All Engines (2013 Emissions) -
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 1659 FMI 7 PID: PSID 109 Engine Coolant System thermostat
All Engines (2010 Emissions) -
