“CLAAS MetaDiag 2007 Update 2016” has been added to your cart. View cart
The pedal message is used to calculate fuel injection.
The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management.
The (VECU) Vehicle Electronic Control Unit is linked to the Engine Control Module (ECM) via these data lines.
Conditions for diagnostic trouble code (DTC):
1) Open circuit
2) The voltage at pin A17.PB:8 is less than 0.7?V
Observable symptoms
1) The engine does not respond when accelerator pedal is pressed.
2) Missing kick-down effect
Probable cause
1) Connector
2) Supply wire, Open circuit
3) Signal wire, Open circuit
4) Signal wire, Short circuit to ground
5) Accelerator pedal, Sensor
-
Detroit Diesel Diagnostic Link DDDL 8.0 PRO PROFESSIONAL Software trucks
Detroit $25.00Rated 0 out of 5 -
DOWNLOAD NISSAN UD DIESEL PC-CONSULT DIAGNOSTIC 1.1.13 & PC-REPROMASTER 1.2.0
NISSAN UD $100.00Rated 0 out of 5 -
International Truck ISIS – Oncommand Service Information Q4.2020 [04.2020]
Navistar $85.00Rated 0 out of 5 -
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2671 Actuator Supply Voltage 2 (HSD2) – High (Batt)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P1790 Gear Shift Module 1 Calibration Invalid
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P097C Shift Solenoid 3 (SS3) Control Circuit – Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2724 Pressure Control Solenoid 1 (PCS1) – Stuck On
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2723 Pressure Control Solenoid 1 (PCS1) – Stuck Off
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2730 Pressure Control Solenoid 1 (PCS1) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0974 Shift Solenoid 1 (SS1) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0976 Shift Solenoid 2 (SS2) Control Circuit – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0980 Shift Solenoid 3 (SS3) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2685 Actuator Supply Circuit Voltage 3 Low (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5
-
Volvo All Engines (2013 Emissions) Fault Code: P208E00 PID: EMS Aftertreatment Reagent Dosing Valve Clogged
All Engines (2013 Emissions)Rated 0 out of 5 -
PACCAR MX (2004 Emissions) Fault Code: U1835 VTG Turbocharger Actuator – CAN, Message Time-Out
MX (2004 Emissions)Rated 0 out of 5 -
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 4337 FMI 2 (ACM) Diesel Exhaust Fluid Metering Unit Temperature – Drift
DD15 EPA10 (2010-13)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P102300 PID: EMS Cold Start Cylinder 3 Fuel Injector Offset Learning at Min Limit
All Engines (2017 Emissions)Rated 0 out of 5 -
Detroit DD15 EPA07 (2007-09) Fault Code: SPN 3250 FMI 31 (MCM) Abnormal Diesel Oxidation Catalyst Temperature Rise
DD15 EPA07 (2007-09)Rated 0 out of 5 -
Volvo All Engines (2013 Emissions) Fault Code: P229E12 PID: EMS NOx Sensor Bank 1 Sensor 2
All Engines (2013 Emissions)Rated 0 out of 5 -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 157 FMI 10 (MCM) Under-Capacity in the High Pressure Circuit
DD15 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 973 FMI 13 (CPC) Engine Retarder Selection Signal is Missing
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Volvo All Engines (2013 Emissions) Fault Code: P100190 PID: EMS Engine Stop Switch
All Engines (2013 Emissions)Rated 0 out of 5 -
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 558 FMI 1 (CPC) Incorrect Wiring of the Idle Validation Switch
DD16 EPA10 (2010-13)Rated 0 out of 5 -
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 21 PID: SPN: 232 FMI: 3 5 Volt Supply voltage high
3406E (Prefix 1MM or 2WS)Rated 0 out of 5 -
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 2791 FMI 14 (MCM) Exhaust Gas Recirculation Valve Actuator Failsafe Mode, Motor ON
DD15 EPA10 (2010-13)Rated 0 out of 5