Volvo All Engines (2010 Emissions) Fault Code: SPN 94 FMI 5 PID: Engine Fuel Delivery Pressure
The Fuel Pressure Sensor is used to detect low fuel pressure system failures. The sensor consists of a pressure sensitive diaphragm and amplifier. Fuel pressure causes the sensor’s diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor’s signal is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:16 is less than 0.2?V
Diagnostic monitor condition
1) Key in ON position
Probable cause
1) Open circuit, Signal wire
2) Open circuit, Supply wire
3) Engine wiring harness
4) Engine Fuel Pressure Sensor
![download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software](https://www.ecuforcetruck.com/wp-content/uploads/2023/05/MPDR-3.7.00-300x300.png)
Related products
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 51 FMI 5 PID: Engine Throttle Position
All Engines (2010 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P05407F PID: EMS Intake Air Heater “A” Control
All Engines (2013 Emissions) -
-
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 100 FMI 1 (MCM) Low Engine Oil Pressure
DD16 EPA10 (2010-13) -
-
-
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 100 FMI 1 (MCM) Low Engine Oil Pressure
DD16 EPA07 (2007-09) -
Volvo Engine D12D AE E3 (Tier 3) Fault Code: PID172 FMI 4 Air Inlet Temperature
D12D AE E3 (Tier 3) -
-
-
-
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 3719 FMI 16 (ACM) Soot Level High
DD16 EPA10 (2010-13) -
-
