Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 3 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) Short circuit to battery voltage on A14.EB:8
Observable symptoms
1) Indicator does not work
2) Water in the fuel can lead to engine failure
3) Low Power
Probable cause
1) Faulty sensor
2) Short circuit to voltage supply, signal wire
3) Connector
4) Engine control module (ECM)
Related products
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
-
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3510 FMI 3 (CPC) High Voltage
DD15 EPA10 (2010-13) -
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P024600 PID: EMS Wastegate Short Circuit High
All Engines (2013 Emissions) -
-
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 558 FMI 3 (CPC) Open Circuit
DD16 EPA07 (2007-09) -
-
-
-
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 34 PID: 190 SPN: FMI: 2 Primary Engine Speed Loss of Signal
3406E (Prefix 5DS or 1LW) -
Volvo All Engines (2017 Emissions) Fault Code: P208E00 PID: ACM Aftertreatment Reagent Dosing Valve Clogged
All Engines (2017 Emissions) -
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P206200 PID: ACM Reductant/Regeneration Supply Control
All Engines (2017 Emissions)
