Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 3 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) Short circuit to battery voltage on A14.EB:8
Observable symptoms
1) Indicator does not work
2) Water in the fuel can lead to engine failure
3) Low Power
Probable cause
1) Faulty sensor
2) Short circuit to voltage supply, signal wire
3) Connector
4) Engine control module (ECM)
![Magic Tuner [paccar, Maxxforce, Detroit, Caterpillar, Delete]](https://www.ecuforcetruck.com/wp-content/uploads/2021/10/1-300x300.png)
Related products
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P2BA700 PID: EMS NOx Exceedence – Empty Reagent Tank
All Engines (2017 Emissions) -
-
Volvo All Engines (2017 Emissions) Fault Code: P250C00 PID: EMS Engine Oil Level Circuit Low
All Engines (2017 Emissions) -
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 631 FMI 8 PID: PSID 124 Calibration memory
All Engines (2010 Emissions) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P020A25 PID: EMS Cylinder 1 Injection timing
All Engines (2013 Emissions) -
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 3485 FMI 14 PID: Aftertreatment DPF Atomization Air Pressure
All Engines (2010 Emissions) -
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 631 FMI 4 PID: PSID 7 Calibration memory
All Engines (2010 Emissions) -
