Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 4 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) Short circuit to ground on A14.EB:8
Observable symptoms
1) Water in fuel indicator
Probable cause
1) Faulty sensor
2) Short circuit to ground in the component or wiring
3) Connector
4) Engine control module (ECM)
![International Truck ISIS - Oncommand Service Information Q4.2020 [04.2020]](https://www.ecuforcetruck.com/wp-content/uploads/2022/01/OnCommand-2020-1-300x300.png)
Related products
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 153 FMI 14 PID: PSID 23 Engine High Resolution Crankcase Pressure
All Engines (2010 Emissions) -
Volvo Engine D12D AE E3 (Tier 3) Fault Code: SID232 FMI 4 5 V Supply
D12D AE E3 (Tier 3) -
-
-
Volvo All Engines (2017 Emissions) Fault Code: P268200 PID: EMS Engine Coolant Bypass Valve Control Circuit Low
All Engines (2017 Emissions) -
-
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 12 PID: 111 SPN: FMI: 2 Coolant Level signal invalid
3406E (Prefix 5DS or 1LW) -
-
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P112100 PID: EMS EGR Temperature Too High
All Engines (2017 Emissions) -
-
-
-
-
