Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:8 is less than 1.2?V
Observable symptoms
1) Water in the fuel can lead to engine failure
Probable cause
1) Faulty sensor
2) Wiring harness
3) Connector
Related products
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 100 FMI 1 (CPC) Oil Pressure Very Low
DD13 GHG14 (2014-16) -
-
-
-
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P064200 PID: EMS Sensor Reference Voltage “A”
All Engines (2013 Emissions) -
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P20B400 PID: ACM Reductant Heater Coolant Control Valve Circuit High
All Engines (2013 Emissions)
