Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:8 is less than 1.2?V
Observable symptoms
1) Water in the fuel can lead to engine failure
Probable cause
1) Faulty sensor
2) Wiring harness
3) Connector
![Volvo Penta EPC 6 Offline VMware [12.2021] VMware](https://www.ecuforcetruck.com/wp-content/uploads/2022/11/VOLVO-PENTA-2021-A-300x300.jpg)
![International Truck ISIS - Oncommand Service Information Q4.2020 [04.2020]](https://www.ecuforcetruck.com/wp-content/uploads/2022/01/OnCommand-2020-1-300x300.png)
Related products
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5
-
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 66 PID: SPN: 54 FMI: 6 Auxiliary Output #06 current high
3406E (Prefix 1MM or 2WS) -
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P222800 PID: EMS Barometric Pressure Circuit Low
All Engines (2013 Emissions) -
-
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 723 FMI 14 (MCM) Swapped Pins
DD16 EPA10 (2010-13)
