Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:8 is less than 1.2?V
Observable symptoms
1) Water in the fuel can lead to engine failure
Probable cause
1) Faulty sensor
2) Wiring harness
3) Connector
![download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software](https://www.ecuforcetruck.com/wp-content/uploads/2023/05/MPDR-3.7.00-300x300.png)
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 91 FMI 13 PID: Accelerator Pedal Position 1
All Engines (2010 Emissions) -
-
-
-
-
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P009013 PID: EMS Fuel Pressure Regulator 1 Control
All Engines (2017 Emissions) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P050E00 PID: EMS Cold Start Engine Exhaust Temperature Too Low
All Engines (2013 Emissions) -
-
-
-
