Detroit DD16 EPA07 (2007-09) Fault Code: SPN 1077 FMI 14 (MCM) Internal or External Leakage of the High Pressure Fuel System (Too High, Leak Down Test)
NOTE: The Motor Control Module (MCM) monitors rail pressure during engine shut down and compares it to a stored learned value. If the bleed-down rate has changed due to leakage and it is below the learned value, this code will set.
DESCRIPTION:
Leakage in high pressure fuel system to high (leak down test).
MONITORED PARAMETER:
Fuel rail pressure.
TYPICAL ENABLING CONDITIONS:
Key off
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Once when enabling conditions met.
TYPICAL DURATION:
30 seconds
DASH LAMPS:
1. MIL
2. CEL
VERIFICATION:
Rail pressure bleed off test using the diagnostic service tool.
![International Truck ISIS - Oncommand Service Information Q4.2020 [04.2020]](https://www.ecuforcetruck.com/wp-content/uploads/2022/01/OnCommand-2020-1-300x300.png)
Related products
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00
