PACCAR MX (2004 Emissions) Fault Code: U17A5 Accelerator Pedal 2 Frequency – Data Valid but Too High on ECU (D420) Pin (B45)
PACCAR MX (2004 Emissions) Fault Code: U17A5 Accelerator Pedal 2 Frequency – Data Valid but Too High on ECU (D420) Pin (B45)
SET CONDITIONS:
The PCI ECU (D420) detects that the frequency of accelerator pedal position sensor 2 is more than 220 Hz.
DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the ignition is on.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected. To validate the repair, monitor the accelerator pedal sensors with the diagnostic service tool.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
Faulty accelerator pedal or wiring
ADDITIONAL INFORMATION:
The accelerator pedal position is determined by two sensors (1 and 2) inside the accelerator pedal. The sensor outputs are PWM signals at a fixed frequency of 180 to 220 Hz. Sensor signals 1 and 2 are reversed compared to each other, meaning that by pressing the accelerator more, sensor 1 shows a decreasing PWM signal and sensor 2 shows an increasing PWM signal. The PCI ECU monitors both sensors separately and together.
Related
-
10 IN 1 FOR CAT SIS Caterpillar 2021 Full Service Dealer INCLUDING CAT 2019 C
CAT $110.00Rated 0 out of 5 -
2021 VOLVO PREMIUM TECH TOOL PTT V2.8.21 VCADS+DEVELOPER TOOL+APCI 2021/09 ( 1 PC )
Trucks software $85.00Rated 0 out of 5
-
DAF Davie Runtime v5.6.1 Davie XDc ll [02.2019] + Expire Fix 302.00 Unlock ( Windows 7 )
DAF $70.00Rated 0 out of 5 -
CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )
CAT $65.00Rated 0 out of 5 -
PF Diagnose 2.0.2.23 Diagnostics Software 2013 – Full Heavy & Medium Duty with OBDII Support – Online Installation Service
PF Diagnose $60.00Rated 0 out of 5 -
ddct Detroit diesel calibration tool (DDCT) v4.5 English Include Calibrations & Metafiles
Detroit $30.00Rated 0 out of 5 -
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5 -
download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software
Hitachi $76.00Rated 0 out of 5 -
Eaton Service Ranger 4.9 Engineering 4.9 [05.2021] Engineering Level ( 1 PC )
Eaton $67.00Rated 0 out of 5
Related products
-
MANUAL SERVICE Deutz Combine 5650 H, 5660 HTS5670 H / HTS5680 H, 5690 HTS
DEUTZ $38.00Rated 0 out of 5