The ambient air temperature signal is sent to the instrument cluster module. The instrument cluster module then transmits the ambient air temperature data to the Engine Control Module (ECM) via the J1939 data lines.
Conditions for diagnostic trouble code (DTC):
1) No ambient air temperature sensor signal
Probable cause
1) Ambient air temperature sensor
2) Wiring harness
3) Ambient temperature below -30??C (-22??F)
-
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5 -
DOWNLOAD Paccar ESA Electronic Service Analyst 5.5.0 Diagnostic Software 2023
PACCAR $96.00Rated 0 out of 5 -
Bobcat Service Library [03.2019] Service, Operator, Maintenance, Bulletines, etc full update
Bobcat $110.00Rated 0 out of 5
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P0973 Shift Solenoid 1 (SS1) Control Circuit – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2723 Pressure Control Solenoid 1 (PCS1) – Stuck Off
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0976 Shift Solenoid 2 (SS2) Control Circuit – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2684 Actuator Supply Circuit Voltage 3 Open (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2730 Pressure Control Solenoid 1 (PCS1) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2685 Actuator Supply Circuit Voltage 3 Low (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P097C Shift Solenoid 3 (SS3) Control Circuit – Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2686 Actuator Supply Circuit Voltage 3 High (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2789 Clutch Adaptive Learning at Limit
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2671 Actuator Supply Voltage 2 (HSD2) – High (Batt)
1000 & 2000 Gen 5Rated 0 out of 5
-
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 5357 FMI 16 (MCM) Fuel Quantity High Detected
DD15 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 84 FMI 19 (CPC) J1939 Wheel-Based Vehicle Speed Signal (VSS) from Source #1, #2, Or #3 is Erratic
DD13 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 2791 FMI 14 (MCM) Smart Remote Actuator 3 (EGR), Wrong Failsafe Calibration
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 608 FMI 14 (CPC) This Fault Code Sets When the CPC Cannot Communicate on the Vehicle CAN Network
DD16 EPA07 (2007-09)Rated 0 out of 5 -
Volvo All Engines (2010 Emissions) Fault Code: SPN 84 FMI 9 PID: Wheel-Based Vehicle Speed
All Engines (2010 Emissions)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 520267 FMI 2 (MCM) Motor Control Module Engine Hours Data Erratic, Intermittent or Incorrect
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Allison WTEC II Fault Code: 34 PID: SPN: 13 FMI: EEPROM, factory calibration block checksum
AllisonRated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: SID 6 FMI 12 Fuel Injector Unit #6
All Engines (2004 Emissions)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 3236 FMI 9 (ACM) Exhaust Mass Signal Not Available via Controller Area Network
DD13 GHG14 (2014-16)Rated 0 out of 5 -
PACCAR MX (2004 Emissions) Fault Code: P1215 Injector Solenoid Valve Cylinder 6 – Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (A8)
MX (2004 Emissions)Rated 0 out of 5 -
Detroit DD15 EPA07 (2007-09) Fault Code: SPN 2659 FMI 1 (MCM) Exhaust Gas Recirculation Flow Target Error (Low Flow)
DD15 EPA07 (2007-09)Rated 0 out of 5