The function identifies and indicates malfunction of the aftertreatment diesel particulate filter (DPF) by analyzing the pressure drop over the aftertreatment DPF. This is done by making a check for deviation between sensor value and a model pressure drop. In some extreme cases the engine will derate.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A137:26 is more than 4.75?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Ground wire
3) Short circuit to 5V, Signal wire
4) Short circuit to battery voltage, Signal wire
5) Wiring harness
6) Aftertreatment DPF Differential Pressure Sensor
7) Aftertreatment Control Module (ACM)
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 3480 FMI 5 PID: PPID 437 Aftertreatment DPF Fuel Pressure
All Engines (2010 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P011511 PID: EMS Engine Collant Temperature Sensor 1
All Engines (2017 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 655 FMI 7 PID: SID 5 Engine Injector Cylinder 5
All Engines (2010 Emissions)