Volvo All Engines (2010 Emissions) Fault Code: SPN 3480 FMI 3 PID: PPID 437 Aftertreatment DPF Fuel Pressure
During DPF regeneration the Aftertreatment Fuel Pressure Sensor monitors the fuel pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. During Air Purge the Aftertreatment Fuel Pressure Sensor monitors the air pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. The Engine Control Module (ECM) uses this input to determine if the system is operating correctly.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:50 is more than 4.8?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit on ground wire
3) Short circuit to voltage supply, signal wire
4) Aftertreatment Fuel Pressure Sensor
5) Engine control module (ECM)
![MAN MANTIS v666 EPC [09.2021] Spare Parts Catalog](https://www.ecuforcetruck.com/wp-content/uploads/2022/01/MANTIS-V666-300x300.png)
Related products
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5 -
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5
-
-
-
-
-
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 14 PID: SPN: 122 FMI: 6 Med/High Retarder current high
3406E (Prefix 1MM or 2WS) -
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P06411C PID: EMS Sensor Reference Voltage “A”
All Engines (2017 Emissions) -
-
-
Volvo All Engines (2004 Emissions) Fault Code: PID 171 FMI 9 Ambient Air Temperature Status
All Engines (2004 Emissions) -
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P060141 PID: EMS Internal Control Unit Memory Checksum Error
All Engines (2013 Emissions)
