Volvo All Engines (2010 Emissions) Fault Code: SPN 3480 FMI 3 PID: PPID 437 Aftertreatment DPF Fuel Pressure
During DPF regeneration the Aftertreatment Fuel Pressure Sensor monitors the fuel pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. During Air Purge the Aftertreatment Fuel Pressure Sensor monitors the air pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. The Engine Control Module (ECM) uses this input to determine if the system is operating correctly.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:50 is more than 4.8?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit on ground wire
3) Short circuit to voltage supply, signal wire
4) Aftertreatment Fuel Pressure Sensor
5) Engine control module (ECM)
![Magic Tuner [paccar, Maxxforce, Detroit, Caterpillar, Delete]](https://www.ecuforcetruck.com/wp-content/uploads/2021/10/1-300x300.png)
Related products
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5
-
-
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 636 FMI 14 (MCM) Swapped Pins
DD15 EPA10 (2010-13) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P253912 PID: EMS Low Pressure Fuel System Sensor Circuit
All Engines (2013 Emissions) -
-
Volvo All Engines (2013 Emissions) Fault Code: P114123 PID: EMS Buffered Idle Validation Switch Wire – ECM Side
All Engines (2013 Emissions) -
-
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P06E817 PID: ACM Sensor Power Supply “C”
All Engines (2013 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P040C00 PID: EMS Exhaust Gas Recirculation Temperature Sensor “A”
All Engines (2013 Emissions) -
