Volvo All Engines (2010 Emissions) Fault Code: SPN 3480 FMI 5 PID: PPID 437 Aftertreatment DPF Fuel Pressure
During DPF regeneration the Aftertreatment Fuel Pressure Sensor monitors the fuel pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. During Air Purge the Aftertreatment Fuel Pressure Sensor monitors the air pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. The Engine Control Module (ECM) uses this input to determine if the system is operating correctly.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:50 is less than 0.2?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Supply wire
3) Open circuit, Signal wire
4) Short circuit to ground, Signal wire
5) Aftertreatment Fuel Pressure Sensor
6) Engine control module (ECM)
Related products
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5 -
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P203164 PID: EMS Exhaust Gas Temperature Sensor Bank 1 Sensor 2
All Engines (2017 Emissions) -
-
-
-
-
-
-
-
-
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 36 PID: 84 SPN: FMI: 10 Vehicle Speed signal rate of change
3406E (Prefix 5DS or 1LW) -
Volvo All Engines (2017 Emissions) Fault Code: P040A64 PID: EMS Exhaust Gas Recirculation Temperature Sensor “A”
All Engines (2017 Emissions) -
-
Volvo All Engines (2017 Emissions) Fault Code: P268F00 PID: EMS Cylinder 4 Injector Data Incompatible
All Engines (2017 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 3245 FMI 5 PID: PPID 436 Aftertreatment DPF Outlet Temperature
All Engines (2010 Emissions) -
-
-
-
