“CLAAS MetaDiag 2007 Update 2016” has been added to your cart. View cart
The preheat Relay controls the preheater from an electric signal from the Engine Control Module (ECM). This function is used to warm up the inlet air during cold conditions. This provides more reliable starting and reduces exhaust emissions during cold starts. Vehicles can be equipped with or without the preheater.
Conditions for diagnostic trouble code (DTC):
1) Output activated
2) Short circuit to battery voltage on A14.EB:25
Observable symptoms
1) Intake air heater (IAH) relay never activated
2) Difficult to start in extreme cold
3) White smoke at cold start
Probable cause
1) Engine wiring harness
2) Connector
3) Intake air heater (IAH) relay
-
2021 VOLVO PREMIUM TECH TOOL PTT V2.8.21 VCADS+DEVELOPER TOOL+APCI 2021/09 ( 1 PC )
Trucks software $85.00Rated 0 out of 5
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P0979 Shift Solenoid 3 (SS3) Control Circuit – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2730 Pressure Control Solenoid 1 (PCS1) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2670 Actuator Supply Voltage 2 (HSD2) – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2669 Actuator Supply Voltage 2 Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0122 Pedal Position Sensor Circuit – Low Voltage
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2789 Clutch Adaptive Learning at Limit
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P1790 Gear Shift Module 1 Calibration Invalid
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2686 Actuator Supply Circuit Voltage 3 High (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P097C Shift Solenoid 3 (SS3) Control Circuit – Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0974 Shift Solenoid 1 (SS1) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5
-
Volvo All Engines (2013 Emissions) Fault Code: P034031 PID: EMS Camshaft Position Sensor “A” Bank 1 or Single Sensor
All Engines (2013 Emissions)Rated 0 out of 5 -
Eaton Gen 2 (AutoShift) Fault Code: 42 PID: SID 61 FMI: 7 Splitter failed to Engage
DTC TRUCKSRated 0 out of 5 -
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 511403 FMI 13 (CPC) Message (PTO Drive Engagement) is Missing
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 986 FMI 19 (CPC) Signal Source #1 or #2 is Erratic
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Volvo All Engines (2013 Emissions) Fault Code: P009E73 PID: EMS Fuel Pressure Relief Control Performance / Stuck Off
All Engines (2013 Emissions)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P048013 PID: EMS Fan 1 Control Circuit
All Engines (2017 Emissions)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 100 FMI 3 (MCM) Engine Oil Pressure Sensor Circuit Failed High
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P114700 PID: EMS Fuel/Rail System Bank 1 Presure – Moderately Too High
All Engines (2017 Emissions)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 3509 FMI 3 (ACM) The 5V Sensor Supply Bank 1 Circuit Failed High
DD13 EPA10 (2010-13)Rated 0 out of 5 -
CAT 3126E Fault Code: 232-04 PID: Flash Code 21 SPN: 620 FMI: 4 5 Volt Supply Below Normal
3126ERated 0 out of 5 -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 3510 FMI 8 (CPC) 2-Channel Accelerator Pedal Supply Voltage Missing
DD15 GHG14 (2014-16)Rated 0 out of 5