Volvo All Engines (2010 Emissions) Fault Code: SPN 656 FMI 12 PID: SID 6 Engine Injector Cylinder 6

Fuel Injector operation is controlled by the Engine Control Module (ECM). The ECM provides a common supply voltage to injectors 4,5,6 (Bank 2) and there are individual output transistor drivers inside the ECM to control each individual injector?s ground circuits. There are two solenoid circuits within the injector; a Needle Control Valve and a Spill Valve. Although they are separate circuits, the same fault code is used to identify a fault in the Needle Control Valve circuit and/or the Spill Valve circuit.

Conditions for diagnostic trouble code (DTC):
1) Resistance too high
2) Injector (INJ) activated

Observable symptoms
1) Low Power
2) Uneven operation
3) Abnormal noise
4) Engine is operating on only 3 or 5 cylinders

Probable cause
1) Injector 6
2) Wiring harness between engine control module (ECM) and injector (INJ)