Volvo All Engines (2010 Emissions) Fault Code: SPN 91 FMI 13 PID: Accelerator Pedal Position 1
The pedal message is used to calculate fuel injection.
The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management.
The (VECU) Vehicle Electronic Control Unit is linked to the Engine Control Module (ECM) via these data lines.
Conditions for diagnostic trouble code (DTC):
1) The accelerator pedal is not connected to the VECU
Probable cause
1) Accelerator pedal
2) Vehicle Control Unit (VECU)
![International Truck ISIS - Oncommand Service Information Q4.2020 [04.2020]](https://www.ecuforcetruck.com/wp-content/uploads/2022/01/OnCommand-2020-1-300x300.png)
Related products
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5 -
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 677 FMI 5 PID: SID 39 Engine Starter Motor Relay
All Engines (2010 Emissions) -
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P204364 PID: ACM Aftertreatment Reagent Tank Temperature Sensor Stuck
All Engines (2013 Emissions)
