“Isuzu US-IDSS 2024 Diagnostic” has been added to your cart. View cart
The pedal message is used to calculate fuel injection.
The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management.
The (VECU) Vehicle Electronic Control Unit is linked to the Engine Control Module (ECM) via these data lines.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A17.PB:8 is more than 4.7?V
Observable symptoms
1) The engine does not respond when accelerator pedal is pressed.
2) Missing kick-down effect
Probable cause
1) Connector
2) Accelerator pedal, Sensor
3) Signal wire, Short circuit to higher voltage
4) Open circuit, Ground wire
-
JOHN DEERE SERVICE ADVISOR 5.3.225 DATABASE AG + CF ENGLISH 2023
John Deere $250.00Rated 0 out of 5 -
Volvo Impact 2021 Trucks & Buses 06.2021 DVD 9116 Spare Parts Catalog
Trucks software $55.00Rated 0 out of 5 -
Hino Diagnostic eXplorer 2 – Hino DX2 1.1.19.1 with keygen unlocked ( Hino trucks )
Hino $50.00Rated 0 out of 5
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P0973 Shift Solenoid 1 (SS1) Control Circuit – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2730 Pressure Control Solenoid 1 (PCS1) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2727 Pressure Control Solenoid 1 (PCS1) Control Circuit – Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2686 Actuator Supply Circuit Voltage 3 High (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2729 Pressure Control Solenoid 1 (PCS1) Control Circuit – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2724 Pressure Control Solenoid 1 (PCS1) – Stuck On
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2685 Actuator Supply Circuit Voltage 3 Low (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2789 Clutch Adaptive Learning at Limit
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2671 Actuator Supply Voltage 2 (HSD2) – High (Batt)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5Rated 0 out of 5
-
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 84 FMI 13 (CPC) J1939 Wheel-Based Vehicle Speed Signal from Source #1, #2 or #3 is Missing
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 3719 FMI 16 (ACM) Soot Level High
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Volvo All Engines (2010 Emissions) Fault Code: SPN 3051 FMI 7 PID: Catalyst 2 System Monitor
All Engines (2010 Emissions)Rated 0 out of 5 -
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 103 FMI 0 (MCM) Turbocharger Speed Below Threshold (Low Box)
DD16 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 84 FMI 2 (CPC) J1939 Wheel-Based Vehicle Speed Signal from Source #1 is Erratic
DD16 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 3242 FMI 20 (ACM) Diesel Oxidation Catalyst Temperature Drift – Inlet High or Outlet Low
DD15 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 713 FMI 3 (CPC) Short to Power
DD13 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD15 EPA07 (2007-09) Fault Code: SPN 411 FMI 1 (MCM) Exhaust Gas Recirculation Delta P Pressure is Too Low at Low Speeds and Loads
DD15 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 677 FMI 7 (MCM, CPC) Engine Starter Relay Jammed
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Allison WTEC II Fault Code: 53 PID: SPN: 78 FMI: Offgoing speed test (during shift), R to N1
AllisonRated 0 out of 5