Volvo All Engines (2010 Emissions) Fault Code: SPN 91 FMI 4 PID: Accelerator Pedal Position 1
The pedal message is used to calculate fuel injection.
The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management.
The (VECU) Vehicle Electronic Control Unit is linked to the Engine Control Module (ECM) via these data lines.
Conditions for diagnostic trouble code (DTC):
1) Open circuit
2) The voltage at pin A17.PB:8 is less than 0.7?V
Observable symptoms
1) The engine does not respond when accelerator pedal is pressed.
2) Missing kick-down effect
Probable cause
1) Connector
2) Supply wire, Open circuit
3) Signal wire, Open circuit
4) Signal wire, Short circuit to ground
5) Accelerator pedal, Sensor
Related products
-
-
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P220064 PID: EMS NOx Sensor Bank 1 Sensor 1
All Engines (2013 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P069200 PID: EMS Fan 1 Control Circuit High
All Engines (2017 Emissions) -
-
-
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 111 FMI 19 (MCM) Coolant Level Low
DD13 EPA10 (2010-13) -
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P054100 PID: EMS Intake Air Heater A Circuit Low
All Engines (2017 Emissions) -
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 723 FMI 4 (MCM) Short to Ground
DD15 EPA10 (2010-13) -
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 412 FMI 5 PID: Engine Exhaust Gas Recirculation Temperature
All Engines (2010 Emissions) -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 1624 FMI 9 (CPC) Message is Missing
DD13 GHG14 (2014-16)
