Volvo All Engines (2010 Emissions) Fault Code: SPN 91 FMI 4 PID: Accelerator Pedal Position 1
The pedal message is used to calculate fuel injection.
The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management.
The (VECU) Vehicle Electronic Control Unit is linked to the Engine Control Module (ECM) via these data lines.
Conditions for diagnostic trouble code (DTC):
1) Open circuit
2) The voltage at pin A17.PB:8 is less than 0.7?V
Observable symptoms
1) The engine does not respond when accelerator pedal is pressed.
2) Missing kick-down effect
Probable cause
1) Connector
2) Supply wire, Open circuit
3) Signal wire, Open circuit
4) Signal wire, Short circuit to ground
5) Accelerator pedal, Sensor
Related products
-
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5
-
Volvo All Engines (2013 Emissions) Fault Code: P03351F PID: EMS Crankshaft Position Sensor “A”
All Engines (2013 Emissions) -
-
-
Volvo All Engines (2004 Emissions) Fault Code: SID 232 FMI 4 Sensor Supply Voltage #1
All Engines (2004 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 5319 FMI 31 PID: Aftertreatment 1 DPF Incomplete Regeneration
All Engines (2010 Emissions) -
-
-
-
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 713 FMI 4 (CPC) Short to Ground Circuit
DD15 EPA10 (2010-13) -
Volvo All Engines (2013 Emissions) Fault Code: P208A13 PID: ACM Reductant Pump “A” Control
All Engines (2013 Emissions) -
-
-
-
-
-
-
-
