The pedal message is used to calculate fuel injection.
The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management.
The (VECU) Vehicle Electronic Control Unit is linked to the Engine Control Module (ECM) via these data lines.
Conditions for diagnostic trouble code (DTC):
1) Open circuit
2) The voltage at pin A17.PB:8 is less than 0.7?V
Observable symptoms
1) The engine does not respond when accelerator pedal is pressed.
2) Missing kick-down effect
Probable cause
1) Connector
2) Supply wire, Open circuit
3) Signal wire, Open circuit
4) Signal wire, Short circuit to ground
5) Accelerator pedal, Sensor
-
VOLVO PREMIUM TECH TOOL PTT 2.7.30 Developer + Devtool + INSTALATION VIDEO!
Trucks software $60.00Rated 0 out of 5
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2671 Actuator Supply Voltage 2 (HSD2) – High (Batt)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2670 Actuator Supply Voltage 2 (HSD2) – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0973 Shift Solenoid 1 (SS1) Control Circuit – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0980 Shift Solenoid 3 (SS3) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2789 Clutch Adaptive Learning at Limit
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2685 Actuator Supply Circuit Voltage 3 Low (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2637 Torque Management Feedback Signal – SEM
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0979 Shift Solenoid 3 (SS3) Control Circuit – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2724 Pressure Control Solenoid 1 (PCS1) – Stuck On
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P1790 Gear Shift Module 1 Calibration Invalid
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5Rated 0 out of 5
-
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 1624 FMI 19 (CPC) Tachograph Vehicle Speed Signal is Erratic
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Allison WTEC II Fault Code: 32 PID: SPN: 00 FMI: C3 pressure switch open in low range
AllisonRated 0 out of 5 -
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 175 FMI 18 (MCM) Engine Oil Temperature Rises Too Slow or Not at All
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 3598 FMI 4 (MCM) Proportional Valve Bank 2 Circuit Failed Low
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 639 FMI 14 (CPC) Data Link Failure
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 2791 FMI 0 (MCM) High Load Operation in High Ambient Temperatures
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 3719 FMI 16 (ACM) Soot Level High
DD16 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 3480 FMI 31 (MCM) Fuel Cut-Off Valve Pressure Not Plausible
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Volvo Engine D12D AE E3 (Tier 3) Fault Code: PID 45 FMI 3 Inlet Air Heater Status
D12D AE E3 (Tier 3)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 520267 FMI 15 (MCM) Motor Control Module Engine Hours Data Erratic, Intermittent or Incorrect
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Volvo All Engines (2013 Emissions) Fault Code: P208D00 PID: EMS Aftertreatment Reagent Pump Control Short Circuit High
All Engines (2013 Emissions)Rated 0 out of 5