Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 3 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) Short circuit to battery voltage on A14.EB:8
Observable symptoms
1) Indicator does not work
2) Water in the fuel can lead to engine failure
3) Low Power
Probable cause
1) Faulty sensor
2) Short circuit to voltage supply, signal wire
3) Connector
4) Engine control module (ECM)
Related products
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: U300257 PID: EMS Vehicle Identification Number
All Engines (2013 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P012012 PID: EMS Throttle/Pedal Position Sensor “A”
All Engines (2013 Emissions) -
-
-
-
Volvo All Engines (2004 Emissions) Fault Code: PID 103 FMI 9 Turbo Speed Sensor
All Engines (2004 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P008B97 PID: EMS Low Pressure Fuel System Pressure – Too High
All Engines (2013 Emissions) -
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P009D00 PID: EMS Fuel Pressure Relief Control Circuit High
All Engines (2013 Emissions) -
-
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 97 FMI 15 (MCM) Water-In-Fuel Warning
DD15 EPA10 (2010-13)
