Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:8 is less than 1.2?V
Observable symptoms
1) Water in the fuel can lead to engine failure
Probable cause
1) Faulty sensor
2) Wiring harness
3) Connector
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
-
-
-
-
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 710 FMI 5 (CPC) Open Circuit
DD15 GHG14 (2014-16) -
-
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P06EF9A PID: EMS Engine Restart Performance
All Engines (2017 Emissions) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P01B913 PID: EMS Engine Oil temperature Sensor “B”
All Engines (2013 Emissions) -
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 647 FMI 3 PID: SID 33 Engine Fan Clutch Output Device Driver
All Engines (2010 Emissions) -
-
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 2646 FMI 3 (CPC) Short to Power
DD15 GHG14 (2014-16)
