“John Deere Service Advisor 5.4.44 2025 (AG & CF) | Nexiq USB Link 3 Compatible” has been added to your cart. View cart
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:8 is less than 1.2?V
Observable symptoms
1) Water in the fuel can lead to engine failure
Probable cause
1) Faulty sensor
2) Wiring harness
3) Connector
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5
-
Volvo Engine D12D AE E3 (Tier 3) Fault Code: SID230 FMI 5 Idle Validation Switch
D12D AE E3 (Tier 3) -
Volvo All Engines (2013 Emissions) Fault Code: P220B1C PID: EMS NOx Sensor Gas Outlet High Voltage
All Engines (2013 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P20B300 PID: ACM Reductant Heater Coolant Control Valve Circuit Low
All Engines (2017 Emissions)