Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:8 is less than 1.2?V
Observable symptoms
1) Water in the fuel can lead to engine failure
Probable cause
1) Faulty sensor
2) Wiring harness
3) Connector
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5 -
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P02E17C PID: EMS Diesel Intake Air Flow Control Performance
All Engines (2017 Emissions) -
-
-
-
-
-
-
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 168 FMI 18 (CPC) Battery Voltage Low
DD15 GHG14 (2014-16) -
-
Volvo All Engines (2013 Emissions) Fault Code: P21CA00 PID: ACM Reductant Control Module Supply Voltage
All Engines (2013 Emissions) -
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P069100 PID: EMS Fan 1 Control Circuit Low
All Engines (2013 Emissions) -
