Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:8 is less than 1.2?V
Observable symptoms
1) Water in the fuel can lead to engine failure
Probable cause
1) Faulty sensor
2) Wiring harness
3) Connector
![Volvo Penta EPC 6 Offline VMware [12.2021] VMware](https://www.ecuforcetruck.com/wp-content/uploads/2022/11/VOLVO-PENTA-2021-A-300x300.jpg)
Related products
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5 -
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5
-
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 190 FMI 0 (MCM) Engine Over Speed
DD16 EPA10 (2010-13) -
-
-
Volvo All Engines (2017 Emissions) Fault Code: P018501 PID: EMS Fuel Temperature Sensor “B”
All Engines (2017 Emissions) -
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 1072 FMI 4 PID: Engine (Compression) Brake Output #1
All Engines (2010 Emissions) -
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 3484 FMI 2 PID: Aftertreatment Ignition
All Engines (2010 Emissions) -
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P242A15 PID: ACM Exhaust Gas Temperature Sensor Bank 1 Sensor 3
All Engines (2013 Emissions)
