The Engine Oil Temperature/Level Sensor contains two resistors: One for engine oil temperature and one for engine oil level.
Diagnostic trouble code (DTC) Placeholder will be present only when a problem with the engine oil level (EOL) circuit has failed. Please reference Placeholder for engine oil temperature (EOT) sensor circuit diagnostics.
The resistance of the engine oil level portion of the sensor changes inversely to the level of the engine oil. The Engine Control Module (ECM) monitors the voltage drop across the sensor and uses this signal to warn that the engine oil level is not within programmed limits. In some cases the engine will derate.
The engine oil level is monitored when the key is on, before the starter is engaged. If low engine oil is detected, either from parking on an incline, or actual low oil, the code will remain active until the next key cycle. It is important that the vehicle is level during key on, or the low engine oil level code may remain.
Conditions for diagnostic trouble code (DTC):
1) Engine oil level (EOL) is below warning level
Probable cause
1) Vehicle Not Parked On a Level Surface.
2) Low oil level
3) Connector
4) Engine Oil Dipstick
5) Engine oil level (EOL) and temperature sensor
Detailed information
1) Engine may have to be off up to 20 minutes depending on temperature before checking the oil level.
-
Wabco ToolBox plus 13.7 + ECAS CAN2 v3.00 Diagnostics Software
Trucks software $84.00Rated 0 out of 5 -
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5 -
volvo Devtool Studio V2 / V3 / V4 Developer tool plus 2.6 / 2.7
Trucks software $35.00Rated 0 out of 5 -
CLAAS WebTIC Offline [11.2021] Service Information – ENGLISH Language
CLAAS $100.00Rated 0 out of 5
Related products
-
PACCAR MX (2004 Emissions) Fault Code: P1162 CAN Communication – Message (TCO1) Out of Range, Vehicle Speed From Tachograph
MX (2004 Emissions)Rated 0 out of 5 -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 5018 FMI 18 (ACM) Diesel Oxidation Catalyst Efficiency Fault
DD15 GHG14 (2014-16)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P102600 PID: EMS Cold Start Cylinder 5 Fuel Injector Offset Learning at Max Limit
All Engines (2017 Emissions)Rated 0 out of 5 -
Volvo All Engines (2010 Emissions) Fault Code: SPN 656 FMI 7 PID: SID 6 Engine Injector Cylinder 6
All Engines (2010 Emissions)Rated 0 out of 5 -
Allison WTEC II Fault Code: 42 PID: SPN: 24 FMI: Short-to-battery, J solenoid circuit
AllisonRated 0 out of 5 -
Allison WTEC II Fault Code: 51 PID: SPN: 10 FMI: Offgoing ratio test (during shift), 1 to L
AllisonRated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 3599 FMI 4 (MCM) Motor Control Module Internal Fuel Injector Power Supply Failed Low
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P220093 PID: EMS NOx Sensor Bank 1 Sensor 1
All Engines (2017 Emissions)Rated 0 out of 5 -
PACCAR MX (2004 Emissions) Fault Code: P1158 Wheel Speed, Front Axle, Left – Data Erratic, Intermittent or Incorrect
MX (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2013 Emissions) Fault Code: P012011 PID: EMS Throttle/Pedal Position Sensor “A”
All Engines (2013 Emissions)Rated 0 out of 5 -
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3480 FMI 14 (MCM) Hydrocarbon Doser Fuel Line Pressure Sensor – Failed Self Test
DD13 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 247 FMI 14 (CPC) MCM Reported Ash Mileage is Lower than the CPC Stored Value
DD15 GHG14 (2014-16)Rated 0 out of 5