The Engine Oil Temperature/Level Sensor contains two resistors: One for engine oil temperature and one for engine oil level.
Diagnostic trouble code (DTC) Placeholder will be present only when a problem with the engine oil level (EOL) circuit has failed. Please reference Placeholder for engine oil temperature (EOT) sensor circuit diagnostics.
The resistance of the engine oil level portion of the sensor changes inversely to the level of the engine oil. The Engine Control Module (ECM) monitors the voltage drop across the sensor and uses this signal to warn that the engine oil level is not within programmed limits. In some cases the engine will derate.
The engine oil level is monitored when the key is on, before the starter is engaged. If low engine oil is detected, either from parking on an incline, or actual low oil, the code will remain active until the next key cycle. It is important that the vehicle is level during key on, or the low engine oil level code may remain.
Conditions for diagnostic trouble code (DTC):
1) Engine oil level (EOL) is below warning level
Probable cause
1) Vehicle Not Parked On a Level Surface.
2) Low oil level
3) Connector
4) Engine Oil Dipstick
5) Engine oil level (EOL) and temperature sensor
Detailed information
1) Engine may have to be off up to 20 minutes depending on temperature before checking the oil level.
Related products
-
Allison 3000 & 4000 Gen 4 Fault Code: P088A Transmission Filter Maintenance Alert
3000 & 4000 Gen 4Rated 0 out of 5 -
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 636 FMI 1 (MCM) Crankshaft Position Sensor Signal Voltage Too Low
DD16 EPA10 (2010-13)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P24B492 PID: EMS Particulate Matter Sensor Heater Control Circuit Range/Performance
All Engines (2017 Emissions)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P10F300 PID: EMS Air Filter Indicator Circuit High
All Engines (2017 Emissions)Rated 0 out of 5 -
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 677 FMI 14 (MCM, CPC) Electronic Starter Fault or Motor Control Module Internal Failure
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 2791 FMI 9 (MCM) Exhaust Gas Recirculation Actuator (Failsafe Mode, Motor OFF)
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Volvo All Engines (2013 Emissions) Fault Code: P020D25 PID: EMS Cylinder 4 Injection Timing
All Engines (2013 Emissions)Rated 0 out of 5 -
Volvo All Engines (2013 Emissions) Fault Code: P102600 PID: EMS Cold Start Cylinder 5 Fuel Injector Offset Learning at Max Limit
All Engines (2013 Emissions)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 1077 FMI 5 (MCM) Quantity Control Valve Current Too Low
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 3563 FMI 21 (MCM) Ambient And Inlet Manifold Pressure Difference (High Box)
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 615 FMI 3 (MCM) Axial Power Turbine Air Seal Pressure Regulator Valve Circuit Failed High
DD15 EPA10 (2010-13)Rated 0 out of 5