The Engine Oil Temperature/Level Sensor contains two resistors: One for engine oil temperature and one for engine oil level.
Diagnostic trouble code (DTC) Placeholder will be present only when a problem with the engine oil level (EOL) circuit has failed. Please reference Placeholder for engine oil temperature (EOT) sensor circuit diagnostics.
The resistance of the engine oil level portion of the sensor changes inversely to the level of the engine oil. The Engine Control Module (ECM) monitors the voltage drop across the sensor and uses this signal to warn that the engine oil level is not within programmed limits. In some cases the engine will derate.
The engine oil level is monitored when the key is on, before the starter is engaged. If low engine oil is detected, either from parking on an incline, or actual low oil, the code will remain active until the next key cycle. It is important that the vehicle is level during key on, or the low engine oil level code may remain.
Conditions for diagnostic trouble code (DTC):
1) Engine oil level (EOL) is below warning level
Probable cause
1) Vehicle Not Parked On a Level Surface.
2) Low oil level
3) Connector
4) Engine Oil Dipstick
5) Engine oil level (EOL) and temperature sensor
Detailed information
1) Engine may have to be off up to 20 minutes depending on temperature before checking the oil level.
-
CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )
CAT $65.00Rated 0 out of 5 -
Wabco ToolBox plus 13.7 + ECAS CAN2 v3.00 Diagnostics Software
Trucks software $84.00Rated 0 out of 5 -
DPF EGR SCR BAC ERG Delete & Flash CAAT Cummings Detroit Dodge Mack Volvo Collection of DELETE files
CAT $200.00Rated 0 out of 5 -
download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software
Hitachi $76.00Rated 0 out of 5 -
10 IN 1 FOR CAT SIS Caterpillar 2021 Full Service Dealer INCLUDING CAT 2019 C
CAT $110.00Rated 0 out of 5
Related products
-
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 641 FMI 4 (MCM) Turbocharger Control Circuit Failed Low
DD16 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 654 FMI 6 (MCM) Injector Cylinder #4 Needle Control Valve Shorted Circuit
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1892 Throttle Position Sensor Pulse Width Modulation (PWM) Signal High Input
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 4814 FMI 3 (MCM) Water Pump Circuit Failed High
DD15 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 3216 FMI 2 (ACM) Selective Catalyst Reduction Inlet NOx Sensor Rationality Error
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 3058 FMI 13 (MCM) MCM Needs to be Reprogrammed
DD16 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 1073 FMI 4 (MCM) Jake Brake Stage 2 Circuit Failed Low
DD13 EPA10 (2010-13)Rated 0 out of 5