PACCAR MX (2004 Emissions) Fault Code: U177E Accelerator Pedal Sensor 1 Duty Cycle – Data Valid but Too Low on ECU (D420) Pin (B41)
PACCAR MX (2004 Emissions) Fault Code: U177E Accelerator Pedal Sensor 1 Duty Cycle – Data Valid but Too Low on ECU (D420) Pin (B41)
SET CONDITIONS:
The PCI ECU (D420) detects that the duty cycle of accelerator pedal position sensor 1 is lower than expected.
DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the ignition is on.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected. To validate the repair, monitor the accelerator pedal sensors with the diagnostic service tool.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
Faulty accelerator pedal or wiring
ADDITIONAL INFORMATION:
The accelerator pedal position is determined by two sensors (1 and 2) inside the accelerator pedal. The sensor outputs are PWM signals at a fixed frequency of 180 to 220 Hz. Sensor signals 1 and 2 are reversed compared to each other, meaning that by pressing the accelerator more, sensor 1 shows a decreasing PWM signal and sensor 2 shows an increasing PWM signal. The PCI ECU monitors both sensors separately and together.
Related
-
VOLVO PREMIUM TECH TOOL PTT 2.7.30 Developer + Devtool + INSTALATION VIDEO!
Trucks software $60.00Rated 0 out of 5 -
download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software
Hitachi $76.00Rated 0 out of 5
-
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5 -
JPRO 2022 v1 Commercial Vehicle Diagnostics V1 Software Download & Installation Service ( 1 PC )
JPRO $94.00Rated 0 out of 5 -
Bobcat Service Library [03.2019] Service, Operator, Maintenance, Bulletines, etc full update
Bobcat $110.00Rated 0 out of 5 -
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5
Related products
-
MANUAL SERVICE Deutz Combine 5650 H, 5660 HTS5670 H / HTS5680 H, 5690 HTS
DEUTZ $38.00Rated 0 out of 5