This diagnostic function indicates malfunction at the exhaust gas temperature (EGT) sensor. The purpose of the exhaust gas sensor is to contribute the relevant temperatures required for the temperature regulated aftertreatment diesel particulate filter regeneration control. A faulty EGT sensor can result with a failed aftertreatment (DPF) regeneration.

Reviews

There are no reviews yet.

Be the first to review “Volvo All Engines (2010 Emissions) Fault Code: SPN 3249 FMI 17 PID: PPID 387 Aftertreatment DPF Intake Temperature – Least Severe Level”

Volvo All Engines (2010 Emissions) Fault Code: SPN 3249 FMI 17 PID: PPID 387 Aftertreatment DPF Intake Temperature – Least Severe Level

Reviews

CLAAS MetaDiag 2007 Update 2016

Isuzu US-IDSS 2024 Diagnostic

Isuzu E-IDSS 2023 Diagnostic Software

ISUZU G-IDSS Domestic Japan 2024 Diagnostic Software

DOWNLOAD NISSAN UD DIESEL PC-CONSULT DIAGNOSTIC 1.1.13 & PC-REPROMASTER 1.2.0

Volvo I-Shift service manual PDF

Bobcat Service Analyzer 92.10 2024

International Truck ISIS – Oncommand Service Information Q4.2020 [04.2020]

Diamond Logic Builder DLB 2018

JPRO 2022 v1 Commercial Vehicle Diagnostics V1 Software Download & Installation Service ( 1 PC )

MANUAL SERVICE DEUTZ AGROTRON 108-118-128

volvo delete files 2023 33,46 GB

Bendix 6.16 ACom Diagnostics ( bendix software trucks )

DOWNLOAD VOLVO MATRIS 2.3.3

premium volvo tech tool update 2.8.150 diagnostic software 1pc

Nexiq eTechnician 2.0.7447 2020

Freightliner ServiceLink 4.9.6

Detroit Diagnostic Link DDDL 8.17

Wabco ToolBox plus 13.7 + ECAS CAN2 v3.00 Diagnostics Software

Related products

Allison 1000 & 2000 Gen 5 Fault Code:P0976 Shift Solenoid 2 (SS2) Control Circuit – Low

Allison 1000 & 2000 Gen 5 Fault Code:P2684 Actuator Supply Circuit Voltage 3 Open (HSD3)

Allison 1000 & 2000 Gen 5 Fault Code:P1790 Gear Shift Module 1 Calibration Invalid

Allison 1000 & 2000 Gen 5 Fault Code:P2727 Pressure Control Solenoid 1 (PCS1) Control Circuit – Open

Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low

Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A

Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open

Allison 1000 & 2000 Gen 5 Fault Code:P0122 Pedal Position Sensor Circuit – Low Voltage

Allison 1000 & 2000 Gen 5 Fault Code:P0973 Shift Solenoid 1 (SS1) Control Circuit – Low

Allison 1000 & 2000 Gen 5 Fault Code:P1892 Throttle Position Sensor (TPS) PWM Signal – High Input

Allison 1000 & 2000 Gen 5 Fault Code:P2789 Clutch Adaptive Learning at Limit

Allison 1000 & 2000 Gen 5 Fault Code:P2685 Actuator Supply Circuit Voltage 3 Low (HSD3)

Volvo All Engines (2017 Emissions) Fault Code: P115000 PID: EMS Throttle/Pedal Position Sensor/Switch “A/D” Voltage Correlation

Detroit DD13 GHG14 (2014-16) Fault Code: SPN 4355 FMI 3 (ACM) Line Heater #2 Circuit Failed High

Detroit DD16 EPA10 (2010-13) Fault Code: SPN 91 FMI 14 (CPC) 2-Channel Accelerator Pedal Not Learned

Cummins ISM CM875 (2003-06) Fault Code: 341 PID: S253 SPN: 630 FMI: 2/2 Engine control module (ECM) data lost.

Detroit DD13 GHG14 (2014-16) Fault Code: SPN 3563 FMI 18 (MCM) Inlet Manifold Pressure Low

Cummins ISB4.5 CM2150 Fault Code: 1677 PID: 205C SPN: 3031 FMI: 4 Aftertreatment Diesel Exhaust Fluid Tank Temperature Sensor – Voltage Below Normal or Shorted to Low Source.

PACCAR PX-9 CM2350 (2013-17) Fault Code:3138 PID: SPN:5019 FMI:2 Engine Exhaust Gas Recirculation Outlet Pressure – Data Erratic, Intermittent, or Incorrect

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 558 FMI 1 (CPC) Incorrect Wiring of the Idle Validation Switch

Detroit DD13 GHG14 (2014-16) Fault Code: SPN 3851 FMI 3 (CPC) Digital Input 2 09 – Failed High on Pin 9 Circuit of the Common Powertrain Controller #2 Connector

Cummins X12 CM2350 X119B (2018 & Newer) Fault Code: 3223 PID: SPN: 3490 FMI: 4 Aftertreatment Purge Air Actuator Circuit- Voltage Below Normal or Shorted to Low Source

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 706 FMI 4 (CPC) Digital Output 3 10 Circuit Failed Low

Detroit DD16 EPA10 (2010-13) Fault Code: SPN 655 FMI 4 (MCM) Injector Cylinder #5 Needle Control Valve Abnormal Operation (MIN)

Allison WTEC II Fault Code: 24 PID: SPN: 12 FMI: Sump fluid temperature, cold

Cummins ISX CM870 (2003-06) Fault Code: 214 PID: P175 SPN: 175 FMI: 0/0 Engine Oil Temperature – Data Valid But Above Normal Operating Range – Most Severe Level. Engine oil temperature signal indicates engine oil temperature above engine protection critical limit.

Volvo All Engines (2013 Emissions) Fault Code: P115800 PID: EMS Reductant Control Module Sensor Power Supply “A” Circuit High

PACCAR MX (2004 Emissions) Fault Code: P1723 Exhaust Gas Pressure Before Turbine – Data Valid but Too Low

Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 2639 PID: SID 324 SPN: 3251 FMI: 15 Aftertreatment Diesel Particulate Filter Differential Pressure- Data Valid But Above Normal Operating Range- Least Severe Level

Volvo All Engines (2017 Emissions) Fault Code: P056E92 PID: EMS Cold Start Turbocharger/Supercharger Boost Control “A” Performance

Store

About

Features

Follow Us