The function identifies and indicates malfunction of the aftertreatment diesel particulate filter (DPF) by analyzing the pressure drop over the aftertreatment DPF. This is done by making a check for deviation between sensor value and a model pressure drop. In some extreme cases the engine will derate.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A137:26 is more than 4.75?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Ground wire
3) Short circuit to 5V, Signal wire
4) Short circuit to battery voltage, Signal wire
5) Wiring harness
6) Aftertreatment DPF Differential Pressure Sensor
7) Aftertreatment Control Module (ACM)
-
2021 VOLVO PREMIUM TECH TOOL PTT V2.8.21 VCADS+DEVELOPER TOOL+APCI 2021/09 ( 1 PC )
Trucks software $85.00
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5
-
Volvo All Engines (2017 Emissions) Fault Code: P11497E PID: EMS Intake Air Heater “B” Circuit
All Engines (2017 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P203864 PID: ACM Reductant Injection Air Pressure Sensor “A”
All Engines (2017 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P050C00 PID: EMS Cold Start Engine Coolant Temperature Performance
All Engines (2017 Emissions) -
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 26 PID: 108 SPN: FMI: 4 Barometric Pressure voltage low
3406E (Prefix 5DS or 1LW)