The function identifies and indicates malfunction of the aftertreatment diesel particulate filter (DPF) by analyzing the pressure drop over the aftertreatment DPF. This is done by making a check for deviation between sensor value and a model pressure drop. In some extreme cases the engine will derate.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A137:26 is more than 4.75?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Ground wire
3) Short circuit to 5V, Signal wire
4) Short circuit to battery voltage, Signal wire
5) Wiring harness
6) Aftertreatment DPF Differential Pressure Sensor
7) Aftertreatment Control Module (ACM)
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5
-
Volvo All Engines (2013 Emissions) Fault Code: P269713 PID: EMS Exhaust Aftertreatment Fuel Injector “A”
All Engines (2013 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P02E601 PID: EMS Diesel Intake Air Flow Position Sensor
All Engines (2013 Emissions) -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 3719 FMI 16 (ACM) Soot Level High
DD15 GHG14 (2014-16) -
Volvo All Engines (2017 Emissions) Fault Code: P253912 PID: EMS Low Pressure Fuel System Sensor Circuit
All Engines (2017 Emissions)