Volvo All Engines (2010 Emissions) Fault Code: SPN 3484 FMI 0 PID: Aftertreatment Ignition
The aftertreatment control module (ACM) supplies a pulsed ground signal to activate the ignition coil. The ignition coil is connected to the ignition electrodes by two ignition wires. When activated it supplies 40,000 to 45,000 volts to the ignition electrodes creating an arc that ignites the atomized fuel and air mixture in the aftertreatment diesel particulate filter (DPF) combustion chamber of the aftertreatment DPF.
Conditions for diagnostic trouble code (DTC):
1) Short circuit to battery voltage on Pin: 21 (Ground wire)
Observable symptoms
1) Regeneration not possible
Probable cause
1) Wiring harness between Aftertreatment ignition coil and Aftertreatment Control Module (ACM)
2) Aftertreatment ignition coil
3) Aftertreatment Control Module (ACM)
![Magic Tuner [paccar, Maxxforce, Detroit, Caterpillar, Delete]](https://www.ecuforcetruck.com/wp-content/uploads/2021/10/1-300x300.png)
Related products
-
-
-
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 21 PID: 41 SPN: FMI: 4 8 Volt Supply voltage low
3406E (Prefix 5DS or 1LW) -
-
Volvo All Engines (2013 Emissions) Fault Code: P20F500 PID: EMS Reductant Consumption Too High
All Engines (2013 Emissions) -
-
Volvo All Engines (2013 Emissions) Fault Code: P25AE00 PID: EMS Piston Cooling Oil Pressure Too Low
All Engines (2013 Emissions) -
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P020511 PID: EMS Cylinder 5 Injector “A”
All Engines (2013 Emissions) -
PACCAR MX (2004 Emissions) Fault Code: P1676 PCI ECU – Software Error
MX (2004 Emissions)
