Volvo All Engines (2010 Emissions) Fault Code: SPN 3484 FMI 0 PID: Aftertreatment Ignition
The aftertreatment control module (ACM) supplies a pulsed ground signal to activate the ignition coil. The ignition coil is connected to the ignition electrodes by two ignition wires. When activated it supplies 40,000 to 45,000 volts to the ignition electrodes creating an arc that ignites the atomized fuel and air mixture in the aftertreatment diesel particulate filter (DPF) combustion chamber of the aftertreatment DPF.
Conditions for diagnostic trouble code (DTC):
1) Short circuit to battery voltage on Pin: 21 (Ground wire)
Observable symptoms
1) Regeneration not possible
Probable cause
1) Wiring harness between Aftertreatment ignition coil and Aftertreatment Control Module (ACM)
2) Aftertreatment ignition coil
3) Aftertreatment Control Module (ACM)
Related products
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P20E797 PID: ACM Reductant Injection Air Pressure Too High
All Engines (2013 Emissions) -
-
-
-
-
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 713 FMI 4 (CPC) Short to Ground Circuit
DD16 GHG14 (2014-16) -
-
Allison 3000 & 4000 Gen 4 Fault Code: P0562 System Voltage Low
3000 & 4000 Gen 4 -
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 110 FMI 5 PID: Engine Coolant Temperature
All Engines (2010 Emissions) -
-
-
