The preheat function is used to warm up the inlet air during cold conditions both before and after cranking to make the starting easier and better for the environment at very low temperatures. This diagnostic trouble code (DTC) detects a faulty preheat function.
Conditions for diagnostic trouble code (DTC):
1) Preheating requested
2) The voltage at pin A14.EB:7 is less than 29?% of the battery voltage
Observable symptoms
1) Intake air heater (IAH) does not function
2) White smoke at cold start
3) Difficult to start in extreme cold
Probable cause
1) Wiring harness
2) Connector
3) Intake air heater (IAH) relay
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5
-
Volvo All Engines (2013 Emissions) Fault Code: P009012 PID: EMS Fuel Pressure Regulator 1 Control
All Engines (2013 Emissions) -
Allison 3000 & 4000 Gen 4 Fault Code: P0736 Incorrect Reverse Ratio
3000 & 4000 Gen 4 -
Volvo All Engines (2017 Emissions) Fault Code: P226401 PID: EMS Water in Fuel Sensor
All Engines (2017 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P20BA00 PID: ACM Reductant Heater “A” Control Performance
All Engines (2017 Emissions) -
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 639 FMI 14 (CPC) Data Link Failure
DD16 EPA10 (2010-13)