Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 0 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) The fuel contains water
2) Defective sensor
Observable symptoms
1) Limited engine speed: 2100rpm.
2) Engine power reduced to 28%
Probable cause
1) Water in the fuel bowl in the fuel filter housing
2) Engine control module (ECM): Defective or faulty
3) Defective sensor
![Magic Tuner [paccar, Maxxforce, Detroit, Caterpillar, Delete]](https://www.ecuforcetruck.com/wp-content/uploads/2021/10/1-300x300.png)
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5 -
-
-
-
-
-
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 36 PID: 84 SPN: FMI: 10 Vehicle Speed signal rate of change
3406E (Prefix 5DS or 1LW) -
-
-
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 631 FMI 3 PID: PSID 124 Calibration memory
All Engines (2010 Emissions) -
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 3480 FMI 2 PID: PSID 108 Aftertreatment DPF Fuel Pressure
All Engines (2010 Emissions) -
-
