Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:8 is less than 1.2?V
Observable symptoms
1) Water in the fuel can lead to engine failure
Probable cause
1) Faulty sensor
2) Wiring harness
3) Connector
Related products
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
-
-
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P242A11 PID: ACM Exhaust Gas Temperature Sensor Bank 1 Sensor 3
All Engines (2017 Emissions) -
-
Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 7 Starter Output
All Engines (2004 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P020A25 PID: EMS Cylinder 1 Injection timing
All Engines (2017 Emissions) -
-
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 1127 FMI 11 PID: PSID 98 Engine Turbocharger 1 Boost Pressure
All Engines (2010 Emissions) -
