The Engine Oil Temperature/Level Sensor contains two resistors: One for engine oil temperature and one for engine oil level.
Diagnostic trouble code (DTC) Placeholder will be present only when a problem with the engine oil level (EOL) circuit has failed. Please reference Placeholder for engine oil temperature (EOT) sensor circuit diagnostics.
The resistance of the engine oil level portion of the sensor changes inversely to the level of the engine oil. The Engine Control Module (ECM) monitors the voltage drop across the sensor and uses this signal to warn that the engine oil level is not within programmed limits. In some cases the engine will derate.
The engine oil level is monitored when the key is on, before the starter is engaged. If low engine oil is detected, either from parking on an incline, or actual low oil, the code will remain active until the next key cycle. It is important that the vehicle is level during key on, or the low engine oil level code may remain.
Conditions for diagnostic trouble code (DTC):
1) Engine oil level (EOL) is below warning level
Probable cause
1) Vehicle Not Parked On a Level Surface.
2) Low oil level
3) Connector
4) Engine Oil Dipstick
5) Engine oil level (EOL) and temperature sensor
Detailed information
1) Engine may have to be off up to 20 minutes depending on temperature before checking the oil level.
-
John Deere & Hitachi Parts ADVISOR 2020 [08.2020] Offline DVD Spare Parts Catalog
John Deere $120.00Rated 0 out of 5 -
Volvo Premium Tech Tool PTT 2.8.130 Diagnostic Software 04.2022 ACPI ( 1 PC )
Trucks software $143.00Rated 0 out of 5 -
JOHN DEERE SERVICE ADVISOR 5.3.225 DATABASE AG + CF ENGLISH 2023
John Deere $250.00Rated 0 out of 5 -
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5 -
CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )
CAT $65.00Rated 0 out of 5 -
JPRO 2022 v1 Commercial Vehicle Diagnostics V1 Software Download & Installation Service ( 1 PC )
JPRO $94.00Rated 0 out of 5
Related products
-
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 175 FMI 14 (MCM) Engine Oil Temperature Out of Range (Drifted Low/High)
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 3246 FMI 16 (MCM) Diesel Particulate Filter Outlet Temperature – High
DD16 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 2631 FMI 1 (MCM, ACM) Low Air Flow
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 625 FMI 4 (CPC) ECAN Link Circuit Failure
DD15 GHG14 (2014-16)Rated 0 out of 5 -
Volvo Engine D12D AE E3 (Tier 3) Fault Code: PPID123 FMI 3 EPG 2 Start And Warmhold
D12D AE E3 (Tier 3)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P114B00 PID: EMS Turbocharger/Supercharger Actuator “A” temperature Low
All Engines (2017 Emissions)Rated 0 out of 5 -
Volvo All Engines (2013 Emissions) Fault Code: P113F12 PID: EMS Buffered Idle Validation Switch Wire – VECU Side
All Engines (2013 Emissions)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 3480 FMI 21 (MCM) Fuel Cut-Off Valve Pressure Not Plausible
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P040312 PID: EMS EGR “A” Control
All Engines (2017 Emissions)Rated 0 out of 5 -
Allison WTEC II Fault Code: 52 PID: SPN: 71 FMI: Offgoing C3PS test (during shift), R to 1
AllisonRated 0 out of 5 -
PACCAR MX (2004 Emissions) Fault Code: P228D Common Rail Fuel Pressure Control – Incorrect
MX (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P228D72 PID: EMS Fuel Pressure Regulator 1 Exceeded Control Limits – Pressure Too High
All Engines (2017 Emissions)Rated 0 out of 5