Cummins ISL CM850 (2003-06) Fault Code: 436 PID: 105 SPN: 105 FMI: 2 Intake Manifold 1 Temperature – Data Erratic, Intermittent, or Incorrect. The intake manifold temperature sensor is reading an erratic value at initial key ON.

Cummins ISL CM850 (2003-06) Fault Code: 436 PID: 105 SPN: 105 FMI: 2 Intake Manifold 1 Temperature – Data Erratic, Intermittent, or Incorrect. The intake manifold temperature sensor is reading an erratic value at initial key ON.

The engine intake manifold temperature is compared to the engine coolant temperature and catalyst inlet temperature at initial key ON. The ECM must not see engine speed for a period of eight hours before this diagnostic will run. If the value of engine intake manifold temperature does not match the temperature readings from the engine coolant temperature and the catalyst inlet temperature within a pre-defined tolerance, this fault code is logged.

Possible causes:

1)Stuck in-range engine intake manifold temperature sensor reading.
2)High resistance in the engine intake manifold temperature sensor SIGNAL or RETURN wires.

On-Board Diagnostics (OBD) Information (Euro 4 and Euro 4 Stage 1+ Certified Engines):

1)The ECM illuminates the malfunction indicator lamp (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails.
2)The ECM turns OFF the MIL after three consecutive ignition cycles that the diagnostic runs and passes. The MIL and fault code can also be cleared using INSITE? electronic service tool.
3)The fault code will be cleared from memory after 40 consecutive drive cycles where the diagnostic runs and passes.

The sensor return configuration for Euro 4 ISL engines has been changed for automotive wiring harnesses manufactured from February 2012 onward. The new style wiring harnesses can be be identified using the method below:

1)Disconnect the ECM connector
2)Disconnect the camshaft position sensor
3)Disconnect the intake manifold pressure/temperature sensor
4)Check for continuity between the intake manifold pressure/temperature sensor RETURN pin, and the camshaft position sensor RETURN pin
5)Check for continuity between ECM pin 47 and the camshaft position sensor RETURN pin
6)Use the table below to determine which harness is fitted to the engine.

NOTE: QSB engines, all C series engines, and all L series engines are not affected by this change.

Possible repairs:

1)Clean the connector and pins.
2)Replace the engine intake manifold temperature sensor.
3)Repair or replace the engine harness.
4)Replace the ECM.